I downloaded V-2.4rc2 Setup and installed successfully.
Then I downloaded V-2.5 zip file from CodePlex and replaced all the files in c:\Program Files (x86)\Visual Leak Detector\ with the ones from V-2.5 zip file.
Then included vld.h file for two dll's dllmain.cpp files which will be run by T.exe.
And build both dlls in x64 debug mode successfully.
Finally pressed F5 to run T.exe but it failed to run displaying an error message box saying something like
[T.exe - application failure]
Could not start up application program(0xc0150002). Press ok to close it.
Can anybody help with this?
thx
=> Ignore this post because I found what was wrong.
Comments: Hello ioannise You are right. There was some mess-up with dlls. At the end of the post, I said to ignore it because I found what went wrong, but I didn't know how to delete that post. Is there any way to delete my own post?
Then I downloaded V-2.5 zip file from CodePlex and replaced all the files in c:\Program Files (x86)\Visual Leak Detector\ with the ones from V-2.5 zip file.
Then included vld.h file for two dll's dllmain.cpp files which will be run by T.exe.
And build both dlls in x64 debug mode successfully.
Finally pressed F5 to run T.exe but it failed to run displaying an error message box saying something like
[T.exe - application failure]
Could not start up application program(0xc0150002). Press ok to close it.
Can anybody help with this?
thx
=> Ignore this post because I found what was wrong.
Comments: Hello ioannise You are right. There was some mess-up with dlls. At the end of the post, I said to ignore it because I found what went wrong, but I didn't know how to delete that post. Is there any way to delete my own post?